Torque Plugin for PROTON cars 2.2.4 [free]

This is a Torque plugin for Malaysian made Proton cars, particularly for Campro engines older than 2010. Read real time data, read error codes.!!
This is the free version with limited sensors/parameters and features. More parameters (a lot more..!) and features are available in the paid version. Try this free
version and if you like it, please buy the full version from Googleplay..!
In the meantime try this free version and please revert to me for issues. My email address as below.
Prerequisite:
1. This is a Torque plugin. You need to get Torque installed in your device. This plugin will NOT work alone.
2. You need ELM327 compliant adapter. Make sure you do not use ELM327 version 2.1 which does not support k-line communications. Get adapters confirmed to work from me or
from ahmad hamidon (youu can get it from http://bit.ly/obd2malaysia ).
3. Please also make sure you follow the instruction below. And make sure connection to ECU is OK before scan error, erase error or check the status to avoid app
crashes.
Installation procedures:
This plugin is for Proton cars. New vehicles with CFE engine does not require any setup. Vehicles with older CAMPRO and CPS engines are supported and requires special
setup as below:
1. This plugin requires full access to OBD device. Check the 'Allow plugin full access' in Settings --> Plugins
2. Create a new vehicle profile in Torque. Under Menu, select 'Vehicle Profile'. then click 'create new profile'...,
3. Name the profile 'PROTON'. Scroll to the bottom and click 'Show advance settings'
4. Scroll to the bottom. In 'Preferred OBD Protocol' select 'ISO 14230(fast init,10.4baud)'
5. Click 'Save'
6. Create another vehicle profile and name it 'Blank' scroll to the bottom and 'Save'. Do not put any advanced settings
7. Select the Proton CPS vehicle profile you created earlier every time you want scan CAMPRO engines other than CFE by tapping on Menu --> 'Vehicle Profile'-->select
the ones that you created. For other vehicles, use the 'Blank' profile.
8. Create custom PIDs from Settings --> Manage extra PID/Sensors --> tap settings and select 'Add predefined set'. Select 'Proton PIDs'.
9. Create displays in 'Realtime Information' by tapping Realtime Information --> go to empty page -->tap menu --> Add display -->pick your meter type -->
Select PIDs that start with {PROTON}.
10. Make sure you go to this page every time you want to use PROTON cars. Otherwise, Torque wouldn't connect to your ECU. You may need to wait for a while for Torque to
connect to your ECU
11. Now you are ready to use the Torque for scanning your car.
12. To scan error codes (or other features in the paid version), tap on this plugin logo (PROTON OBD). Please make sure connection to ECU is OK before scanning to avoid
apps crashes

• 04/30/2018: Torque Plugin for PROTON cars 2.2.4
• Report a new version